Awww, Rats! New Canadian Electrical Code Calls for Rooftop Solar System Rodent Guards

By June 10, 2016 July 22nd, 2016 2,458 Comments

On May 5th, a new requirement went into effect in the Canadian Electrical Code. Rule 50-018 has been added to the CE Code which specifically requires added protection for rooftop solar systems. This addendum is designed to eliminate risk of disease, damage, and even fire from rodent infestation. The changes to the CE Code include:

“The… new sub rule will require photovoltaic source circuits installed on or above a building to be protected against damage from rodents unless DC arc-fault protection is located at the module. An Appendix B note has also been added indicating that material such as expanded metal, solid metal, and screening can be used to enclose photovoltaic source circuit conductors as protection against damage from rodents.”

Risk from Rodsquirrel_solatriments

There is good reason to mandate protection against rodents and other pests. Infestation has been demonstrated to lead to:
• Frayed and broken wiring that disrupts service and can cause arcing and grounding issues;
• Structural damage from wood rot;
• Disease from droppings and rotting debris;
• Invalidated warranties for solar modules and inverters, and perhaps most importantly
• Risk of fire.

For example, in March of this year a fire in Mississauga, Ontario, was directly linked to rodent damage to solar cabling. The Illinois Department of Public Health estimates that one quarter of all fires are due to “unknown causes,” many of them likely rodents chewing on wires and creating a short circuit.

Here’s a fact worth considering: a squirrel’s incisors can grow to six inches in a year. To keep their teeth worn down squirrels will chew anything at hand, and if they are nesting in a warm, dry location such as under a solar array, they will chew on wires, insulation, or anything in the immediate area.

The Costs of Infestation

Failure to prevent rodents and other pests from nesting under your solar array can be costly. The average cost to replace all the wiring and micro-inverters due to rodent damage can range from $3,000 to $4,000 per service call. That’s a substantial cost to customers, and can be even costlier to installers if they have to service a system that is still under warranty.

Compliant Barrier Materials

Note, too, that the CE Code specifies the possible use of “expanded metal, solid metal, and screening” as a protective screen. Installers should consider the materials that work best to do the job in terms, taking into consideration longevity and effectiveness as well as ease of installation. Any solar installer who has tried to protect a system using chicken wire can attest to the difficulties. Wire mesh is not only difficult to handle, it’s hard to install and requires special clips or tools to attach it to the solar system frame; techniques that could prove to be impermanent or in some cases, invalidate the module warranty. And chicken wire will fail over time, leaving gaps that will allow critters to nest under solar systems. Similarly, solid metal solutions can be difficult to install, but more importantly they do not allow for adequate circulation which would raise backside module temperatures above recommended ranges, not to mention making roof inspection difficult.

SolaTrim addresses these challenges right out of the box. The SolaTrim protective barrier is made from diamond-stamped aluminum – rigid enough to provide lasting protection while allowing air to circulate. And SolaTrim panels are installed using a peel-and-stick adhesive that has been tested for long-term adhesion in any weather conditions at any temperature, so there are no clips, screws, or rivets that could invalidate a warranty. Plus, the SolaTrim barriers provide an attractive, finished look you won’t get with wire-cage products.

Unlike Canada, the United States doesn’t have a national electrical code for solar, although smart solar installers see the advantages of including SolaTrim protective barriers with their solar installations. Not only do SolaTrim protective barriers reduce service costs, they improve the look of the finished system and increase customer satisfaction, which results in increased referrals. For both the installer and the customer, the added protection will more than pay for itself over time.

(For more about solar system pest abatement, see our article in Solar Power World.)